Arlon DPF White Ultra Tack Arlon’s DPF is a 90 micron, satin white, high-tensile, PVC film with aggressive, permanent adhesive. Designed to stick to . The ultimate premium film for hard to stick surfaces. A durable film combined with a high tack adhesive system allows you to use one film for all your difficult. “We use Arlon DPF every day because of its durability and price point. We wrap a lot of brick walls and needed something that would hold up in heavy.
|Published (Last):||4 July 2014|
|PDF File Size:||18.13 Mb|
|ePub File Size:||13.48 Mb|
|Price:||Free* [*Free Regsitration Required]|
Where it is practical, two people on the removal make the job go far faster than using just one. These surfaces benefit from slightly roughening with sandpaper before installation or surface oxidation with flame.
Removal steps are much easier as the adhesive will remove more cleanly and if any adhesive remains, the surface will be cleaned of residue more easily. Plastic These surfaces benefit from slightly roughening with sandpaper before installation or surface oxidation with flame.
Arlon DPF Mil 5yr | FELLERS
Standard warranty applies to vertical applications only. The surface should be entirely dust free: For many polyolefinic surfaces, once the oily skin of the plastic is modified bond will improve dramatically.
Where only one person is working there will be constant starting and stopping in addition to the problems of the heat being very inconsistent. Remove the film in a continuous smooth motion at a shallow angle for the fastest separation.
When printing this product be vigilant about drying the finished decal completely before laminating, top coating or installing.
Click here to see the WrapItRight video: Graphics Removal Remove the film in a continuous smooth motion at a shallow angle for the fastest separation. Moisture cannot wick to the adhesive surface from within the matrix of the wall. Non-vertical applications are not warranted for this product. The surface must be sealed with a complete coat of paint or concrete sealer and allowed to dry. If the surface is not sealed there must be no loose paint, grit or chalk present.
Rough surfaces may not carry the standard warranties. Due to the porosity of certain types of plastics i. To assure highest adhesion the graphics will benefit from a final installation pass using a soft roller and heat source in combination.
Addition of heat during removal will make the process much cleaner and faster. Printed durability is dependent on the ink system used. Special Considerations Because of the porous nature of all masonry and its general roughness, Arlon does expect water, snow or ice to seep between the film and wall and collect on the upper edges of the applied graphic. The film installs best on flat surfaces when processed and applied according to Arlon recommendations.
Concrete, Masonry, and Tile The surface should be entirely dust free: This is contingent upon no rain or harsh outdoor weather conditions.
The trade-off for high tack and adhesion is to expect higher visible shrinkage than normal.
DPF 8000™ Ultra Tack
With one person working the heating unit in front of the second person who is peeling film, the job proceeds at a uniform and consistent pace. For this reason, an edge seal is recommended for applications that have very rough surfaces.
Dust due to ablation cannot develop under the vinyl. As a result, it is best practice to not leave the printer unattended when printing to avoid headstrikes due to adhesive build up arlob the film edges arloh time. We do not recommend wrapping gasoline atlon or similar plastics exposed to like fumes. Because of the porous nature of all masonry and its general roughness, Arlon does expect water, snow or ice to seep between the film and wall and collect on the upper edges of the applied graphic.
The film should be heated to a point of softening. Application in cold temperature environments. Sealing porous surfaces creates three benefits: PP, PEplastics exposed to gasoline from tanks will migrate through plastic and interfere with vinyl adhesion to the plastic.